Formation tanks
The formation tank has been studied in order to be completely customized to the user exigences.
In fact, the length and the width can be chosen by the user. It is completely made in stainless steel 316 L except for some accessories described here below:
- Length: Customized
- Internal width: Customized
Execution:
A complete solution
Each tank is equipped with:
Exhaust gas aspiration composed by:
Execution
- 1 support frame: AISI 316 L
- 1 aspiration hood: AISI 316 L
- 8 vertical sliding windows: Polycarbonate
- 2 micro switch for sliding doors: Polyester
Endcap
Execution
- Type: Automatic
- Head: AISI 316 L
- Frame: AISI 316 L
- Gasket: EPDM
- Sensors: Micro switch
Belt conveyor
Execution
- Belt: PP width 1.160 mm.
- Sprockets: PP
- Gear motor: standard endless screw
- Shafts: AISI 316 L
- Sliding table: AISI 316 L / Polizene
- Bearing: C 40
- Sealing: FPM / AISI 316 L
Water circulation system
- Circulation pump in AISI 316 L with a flow rate of 15 cm per hour
- Manual valves and filtration unit in PVC
- Distribution pipe in PVC DN 32
Water filling, refilling and discharging
- 1 Over flow out let DN 80
- Automatic valve in PVC for water filling DN 40
- Automatic valve in PVC for water refilling DN 25
- Automatic valve in PVC for discharging DN 80
- Pneumatic board
Water level control
- Temperature control
Temperature control
- 1 probe PT 100 in stainless steel 316 L
Electrical panel
Panel will be equipped with switches for the manual and local control of :
- Cooling water discharge ( end cycle )
- Cooling water filling ( start cycle )
- I/O remote slave, to be interfaced with the PLC master.
- HMI panel for the display of working conditions and parameters.
Cooling water filling and refilling are completely automatic according to the settled parameters, while the conveyor belt moves automatically according to the settled recipe, step by step, inserting one row of batterie at a time.